Rollshutter Installation Instructions, 17
©Copyright TALIUS
iii)
If equipped with two-part safe guide rails, simply insert the stoppers before installing the guide rail caps.
Attach the rounded-top rail cap to the vertical guide rail mount by first clipping the outside hooks together,
then pressing the inside hooks together until they snap closed. Start at the bottom and move upwards.
11.1c) Rollshutter equipped with surface stoppers: Attach them now with the supplied bolts and washers in the pre-drilled
locations.
Section 12: Sill Installation
If the Rollshutter or Rollshutter has a natural sill to rest on or is mounted at the floor level such as in the case of a
rolling door or many patio doors, proceed to the next section. Use the manual operator to lift the curtain halfway up.
For electric Rollshutters use the tester cable switch. L-sill should be installed below the rails, U-sill should be installed
between the rails. Install the sill with 2" - 3" (50 - 75mm) long screws. Space the screws every 16" (40cm) or less. If
using a U-sill for extra security, drill a sufficient number of weep holes through the bottom for water/moisture drainage
To Next Page
Loading...