The control panel User guide
34
Setup mode In this mode, the following settings are available:
` Setup key: Sets the printer to setup mode, in which the following
settings can be selected:
` Menu key (1): Other menu settings. Acces may be disabled by
the manufacturer (see note below).
` Adjust key (2): Sets the Tear position, first printing line and print
head gap.
` Paperway key (3): Sets the Paper path.
` Char key (4): Sets the font and the number of characters per
inch.
Access to the other menu settings (Menu) may be disabled by
the manufacturer.
Proceed as follows to release this lock temporarily.
1 Switch off the printer for approx. 5 seconds.
2 Switch the printer on again keeping the Setup key pressed.
For information on how to enable access permanently and
about the available settings, refer to the section Menu lock
(MenLock) (page 81) and Menu parameters (page 63).
Adjust Paperway
Menu Char
Online
Setup
21
3
4
To Next Page
Loading...
