Need help?Do you have a question about the Tally T6215 and is the answer not in the manual?
Introduces the technical aspects, design, and specifications of the printer.
Details the menu operations for printer maintenance and troubleshooting.
Lists error messages, fault conditions, and corrective actions for printer issues.
Provides step-by-step instructions for disassembling and reassembling printer parts.
Explains the procedure for updating the printer's firmware.
Describes the electronic design structure, including main modules and components.
Details the primary components within the printer's engine control module.
Details personnel hazard areas and protective functions against overload.
Explains the purpose and access to Tech Access Mode for repair technicians.
Step-by-step guide to activating the printer's technical access mode.
Introduces printer tests, hex dumps, and diagnostic routines.
Overview of the Test menu for printer operation testing and fault control.
Explains how to control fault reporting and disable specific fault systems.
Describes calibration procedures for hammer timing and sensors.
Step-by-step guide for performing hammer calibration.
Procedure for calibrating the platen gap setting.
Overview of troubleshooting printer problems, messages, and quality issues.
Lists and explains display messages and their corrective actions.
Explains how printer faults are indicated and general fault correction procedures.
Step-by-step process for diagnosing and correcting printer faults.
A comprehensive table detailing printer error messages and their remedies.
Addresses problems not indicated by error messages, focusing on hardware issues.
Identifies common causes and troubleshooting steps for power issues.
Diagnoses issues where the printer powers on but the control panel is unresponsive.
Troubleshoots issues with an erratic or non-functional control panel display.
Addresses problems where the printer runs but produces no output.
Troubleshoots causes for light or faint printed characters.
Diagnoses causes for shaky or fuzzy print quality issues.
Identifies reasons why specific character columns fail to print.
Troubleshoots issues when the printer indicates no paper, but paper is present.
Addresses faults related to the paper motion sensor not reporting correctly.
Lists common paper handling issues and their corrective actions.
A flowchart for diagnosing power-on issues.
A flowchart for diagnosing issues related to print data processing.
A comprehensive list of component removal and replacement procedures.
Instructions for replacing the 13-pack hammer assembly.
Steps for adjusting the platen gap after component replacement.
Step-by-step instructions for updating the printer's firmware.
To Next Page
General
