Tally T6215 - Clear; Clear Selections; Energy Star; Paper out Thold

T6215 Maintenance Manual
2–14
Ribbon Threshld
This parameter allows you to set the Ribbon Sensor Threshold value for the Ribbon Motion
Sensor.
Threshold selections:
1–255
Paper Out Thold
This parameter allows you to set the Paper Out Threshold value for the Paper Out Sensor. By
using this, you can compensate for the reflectivity of different types of paper. Selections are 1-
255.
Energy Star
This parameter allows you to control Energy Star Operation. Selections are OFF and ON.
Clear
This parameter provides you with a means of clearing part or all of NVRAM.
Clear selections
Calibrations Clears the calibration data from NVRAM. When CalData is selected you must
perform a Hammer Calibration Routine before using the printer.
Counts Clears the count information from NVRAM.
NVRAM Clears ALL NVRAM.
Shuttle Off
This parameter allows you to set the amount of time the shuttle remains at speed after the last
printed data. Options are 10 Sec, 20 Sec, 30 Sec, and 60 Sec.
Shuttle Change
The printer checks for incoming data that uses a different shuttle speed. This parameter allows
you to determine how much of that data is required before an actual shuttle speed change
occurs. Options are 1-30.
Ribbon Ink, Dots per Pump
This parameter allows you to adjust the number of dots printed before the next pump of the ink
is added to the ribbon. Options are 500-2000.
Serial Dump
When this parameter is enabled, the data the printer receives from the parallel port of PSIO
cards is replicated and sent out from the serial port. This allows you to connect a serial cable
from the printer to a computer and capture the data using a serial capture utility.