User guide Table of contents
III
Menu handling 59
Save settings 59
Selecting the LC display language 60
Terminating Setup mode 61
Menu structure 62
Menu parameters 63
Printing out menu configurations (Print) 63
Loading menu configurations (Menu) 63
Reset to default values (Reset) 64
Quietmode (Quietm.) 64
64
Selecting font (Font) 65
Setting character density (CPI) 66
Setting line spacing (LPI) 66
Skiping perforation (Skip) 67
Selecting start signal for escape sequence (ESCChar) 67
Selecting emulation (Emulate) 68
Bidirectional printing (Bidir) 68
Settings for interfaces (I/O) 69
Serial interface (Serial) 69
Data transmssion rate (Baud) 69
Data format (Format) 70
Further Settings (Special) 71
Error handling (ErrMode) 71
Block end character (Blockend) 71
Signal feedback (Remote) 72
Transparence (Handthr) 72
Protocol (Protocol) 73
Signal Processing (DTR) 73
Selecting interface (Interf.) 74
Interface buffer (Buffer) 74
Ethernet interface (ETH-INT) 75
Setting IP address (IP Addr) 75
Setting Gateway address (Gateway) 75
Setting Subnet mask (Subnet) 76
IP address administration
(IP Get M) 77
Banner page (Banner) 77
Selecting character set (CG-Tab) 78
IBM character set (CharSet) 78
To Next Page
Loading...
