- 7 -
5. Setting the Time
Example: Setting the time 9:30 a.m. (assume the time displayed is “00 00 00”)
Press the {Select} button and position the
▲
under the “TIME” mark. At that moment, the
“Hour” flashes.
(
The flashing means it can be
changed.
)
Press the {Change} button to set at “09” And
then press the {Set} button. At that moment, the
flashing changes from “Hour” to “Minute”
Press the {Change} button to set at “30” And
then press the {Set} button. At that moment, the
“Second” starts to run from “00”.
After you finish setting the time, press the {Set}
button once again. Now the time setting has been
completed.
Replace the cover and lock.
*** Important: If you do not complete Step 4,
the Time Stamp will not print.
To Next Page
Loading...