What to do if my Targetmax NT-20A Postal Equipment Time Stamp does not operate?
If your Targetmax Postal Equipment Time Stamp is not operating, make sure the power cord is properly plugged into the AC outlet.
What to do if I enter an incorrect password on my Targetmax NT-20A Postal Equipment?
If you've entered an incorrect password on your Targetmax Postal Equipment, simply enter the correct password again.
What to do if the card is jammed in Targetmax NT-20A Postal Equipment?
If a card is jammed in your Targetmax Postal Equipment, press the push bar and simultaneously try to pull the card out.
General| Brand | Targetmax |
|---|---|
| Model | NT-20A |
| Category | Postal Equipment |
| Language | English |
Step-by-step guide for quick device setup.
Explanation of SELECT, CHANGE, and SET buttons for programming.
Adjust hour, minute, and second values for accurate time display.
Adjust year, month, and day values for accurate date display.
Choose between 12-hour and 24-hour display formats.
Select the desired sequence for printed information.
Choose between 2-digit or 4-digit year display for prints.
Choose between 12-hour or 24-hour format for the hour display.
Select the desired minute precision (e.g., 1/60, 1/100).
Enable or disable leading zeros for time and date display.
Choose a preprogrammed comment from the available options.
Define print order and horizontal alignment for customized comments.
Enter characters for the first line of the customized comment.
Enter characters for the second line of the customized comment.
Enter characters for the third line of the customized comment.
Verify the entered customized comments before finalization.
Review the characters entered for the first comment line.
Modify the second comment line from year to time format.
Choose the desired language for print output from the available options.
Select the print direction (Left or Right).
Configure how the print is activated (Automatic, Manual).
Define the start date for Daylight Saving Time.
Define the end date for Daylight Saving Time.
Configure the number of digits for sequential numbering.
Determine how many times the number repeats.
Configure the reset behavior for the number.
Set the sequential digits for the initial number.
Enter and confirm the 4-digit password for security.
Enter the password to access and modify settings.
Input the code '0000' to cancel the password.
Step-by-step guide to remove old and install new ribbon cartridges.
Lookup table for alphanumeric character codes.
Character codes categorized by language.
Guide on how to install the optional battery pack.
Procedures for securely mounting the time stamp to a wall.
Details on dimensions, power, and operating environment.
Important warnings regarding usage and environment.
To Next Page