74 TASCAM DA-98HR
11 – Menu and parameter reference
11.1 Menu groups
This section provides a quick guide to the menus and
their functions, providing a list of menus in each
menu group, the parameters available in each menu,
and the values that each parameter can take (default
values are underlined). There is also, wherever
appropriate, a reference to the section of the manual
which describes the function.
Please note 11.2, “Menu item index” which provides
an alphabetically-sorted list of menu functions.
11.1.1 Menu group 0
11.1.2 Menu group 1
Menu item Parameter(s) Values Reference
Track Delay Time
Tra ck
Delay time
Unit
1
through
8
,
ALL
-200
through
7200
(samples)
-4
through
150
(msec) – default
0
sample
,
msec
7.3, “Track delay”
Input Patch
Input patchbay
Allows assignment of inputs from tape (
T
),
optional slot board inputs (
S
)or digital inputs (
D
)
or muting (
M
)
6.3.3, “Selecting input
sources”
Vari Speed
Enabled
Amount
Fix
,
Vari
-6.0%
through
+6.0%
(default is
0.0%
)
7.5, “Vari speed (pitch
control)”
Memo 1
Time value Defaults to
00:00:00:00
7.1, “Autolocation”
Memo 2
Locate Preroll
Minutes and
seconds
00min00sec
through
59min59sec
7.1.3, “Setting the
location pre-roll time”
Menu item Parameter(s) Values Reference
Punch-in Point
Time value Defaults to
00:00:00:00
6.6, “Punch-in and
punch-out”
Punch-out Point
Preroll Postroll
Pre-roll time
Post-roll time
00m05s
through
59m59s
00m03s
through
59m59s
6.6.5, “Editing the pre-
roll and postroll times”
Crossfade Time
Milliseconds
10
ms through
200
ms in 10 ms steps
7.4, “Crossfade time”
Dither
Type of dither
off
,
Rectangular
,
Triangular
7.12, “Dither”
Rec Mute
Track muting On or off for each track 7.11, “REC MUTE
(recording silence)”
D e l a y M e m o 1
I n P a t c h M e m o 2
V a r i S p d L o c P r e
I n P o i n t X - F a d e
O u t P o i n t D i t h e r
P r e / P o s t R e c M u t e
To Next Page
