Tascam DA-98HR - Menu Group 4; Menu Group 5

11 – Menu and parameter reference–Menu groups
76 TASCAM DA-98HR
11.1.5 Menu group 4
11.1.6 Menu group 5
Menu item Parameter(s) Values Reference
TC Chase Indiv.
Rec
Enabled
enable , disable
9.6.12, “Individual
recording while chasing
timecode”
Rechase Mode
Mode
Window
rechase , free
1 sec. , 2 sec
9.6.10, “Rechasing
timecode”
Error Bypass
Time in frames
10 Frame , 30 Frame
9.6.11, “Bypassing
timecode errors”
Timecode Offset
Time to sub-
frame accuracy
Defaults to
+00:00:00:00.00
±12:00:00:00.00
9.6.2, “Setting time-
code offset”
Park Position
Te st
Manual entry
off , on
00s00f through 2 seconds minus 1 frame
9.6.7, “Park position”
TC Accuracy
Width of accu-
racy
Normal , Wider
9.6.6, “Timecode accu-
racy”
Menu item Parameter(s) Values Reference
TC Frame Mode
System frame
rate, TC track
rate (view-only)
30 DF,30 NDF, 29.97 DF ,
29.97NDF , 25 F , 24 F
9.4, “Selecting the
frame rate”
TC I/O Timing
Input and out-
put timing refer-
ence for
timecode
Analog , Digital for both input and
output
9.5.4, “Timecode input
and output timing”
Output TC Source
Source of time-
code output
TAPE (ABS or TC Track ) ,
External (regen) ,
External (reshape)
9.5.2, “Timecode out-
put”
Fast LTC Mode
Linear time-
code in fast
wind
05 Frame , Leap , off
9.5.3, “Timecode out-
put format”
Video Resolve
Enabled
Mode
on , off
free , re-sync
9.7, “Video resolution”
Tape TC Mode
Mode
TcTrack , ABS , ABS-Ofs
a
,
ABS-13 , ABS-23
a.If the ABS-Ofs (Absolute timing with offset) option is selected, the bottom line of the display changes to allow direct
entry of the desired offset value.
9.2, “Tape timecode
mode”
T c C h s R e c T C O f f s e t
R e c h s M o d e P a r k P o s i
E r r B y p a s s T C A c c r c y
T C F r a m e F a s t L T C
T C T i m i n g V i d R s l v
O u t T c S r c T a p e T C