DM-3200 Release Notes
12 TASCAM DM-3200 Release Notes V1.50
MIDI control
External MIDI devices can now be operated from a
DM-3200, using MIDI Control Change messages and
MIDI Program Change messages using the MIDI controller,
MIDI fader, and MIDI Mixer screens.
Remote operation through MMC
DM-3200 Ver1.20 allows you to remotely operate the trans-
port functions of external devices through MMC (MIDI
Machine Control). Device control is carried out through
the MIDI IN/OUT port. The USB port cannot be used for
this purpose.
Selection of external devices for transport control is done
on the REMOTE/MACHINE CTRL screen. For details, please
see “Selecting devices for transport control” on page 93 of
the DM-3200 Owner’s Manual. As a result of this additional
function, the following information is added to “Table 8.3:
Supported transport machine control devices” on page 93.
Device Screen display Control type
MIDI open loop MMC Open M
MMC closed loop MMC Full M
Figure 5: Supported transport machine control devices
added in Ver 1.20
Some devices, such as the Alesis HD-24, only support a
limited range of functions over MMC, and may not support
closed loop MMC control.
The MMC ID is set from the ID field on the MACHINE
CTRL screen, selectable between 1 and 127 using the
JOG/DATA dial.
These numbers correspond to 0 through 126 in the MMC
protocol, so the controlled device may require you to set an
ID of 0 to match the ‘1’ on the DM-3200, for example. The
all-call ID number, 127 in the MMC protocol, is not used
by the DM-3200.
2 ENTER a name you like.
For more information about the method for enter-
ing names, please refer to “Naming library entries”
on page 32 of the DM-3200 Owner’s Manual.
3 Save the name by pressing the POD 2 key (STORE).
The pop-up window will disappear and the name
you entered will appear in the MIXER NAME section.
Figure 4 shows an example of the screen display
when the entered name is “DM-3200.”
Figure 4: UTILITY>SYSTEM screen when the mixer is
named “ DM-3200”
To Next Page
Loading...
Need help?
General
