DM-3200 Release Notes
14 TASCAM DM-3200 Release Notes V1.50
MIDI controllers
You can send MIDI Control Change messages using the
POD knobs of DM-3200.
Figure 8: MIDI CONTROLLERS screen
The MIDI CONTROLLERS screen comes with standard
controllers. Use the cursor key to move the bordered frame
indicating the control messages you want to use, and use
the POD knobs to send MIDI Control Change messages.
This can be done whenever the MIDI CONTROLLERS screen
is displayed regardless of the setting of the Layer Status.
When a Control Change message is received from an
external MIDI device, the value will be reflected on the
DM-3200’s MIDI CONTROLLERS screen.
MIDI fader
Using the DM-3200 faders, you can send MIDI Control
Change messages to all 16 MIDI channels of an external
MIDI device.
Figure 9: MIDI FADERS screen
As shown in figure 9, you can select and set the MIDI
Control Change number on this screen.
MIDI Volume (Control Change 7) is frequently used. This
allows the DM-3200 to remotely control the sound volume
of up to 16 external MIDI devices. This is only possible
when Layer Status is set to REMOTE and the MIDI FADERS
screen is currently showing or was the last EXT.CTRL screen
displayed.
When a Control Change message is received from an
external MIDI device, the value will be reflected in the
fader of DM-3200.
To Next Page
Loading...
Need help?
General
