Taylor 104 User Manual

Section 8
8-1
Model 104
Troubleshooting
8
Troubleshooting
Problem Probable Cause Remedy
Page
Ref.
1. Poor ejection. a. Over refrigeration. a. Use less time to run the batch. - - -
b. Inadequate pre-charge b. Increase the pre-charge. - - -
c. The beater is rotating
counterclockwise.
c. Contact service technician to correct
beater rotation to clockwise.
- - -
2. No beater operation with
the control switch in the
AUTO position.
a. The machine is unplugged. a. Plug into wall receptacle. - - -
b. The circuit breaker is off, or the
fuse is blown.
b. Turn the breaker on or replace the
fuse.
- - -
c. The machine is out on reset. c. Put the freezer in the OFF position.
Allow the machine to cool. Resume
normal operation, but use less time to
run the batch.
5-1
d. The freezer door is open. d. Secure the door for freezer operation. 6-2
3. The product is not
freezing.
a. The timer control is not set or is
defective.
a. Set time for required batch or contact
service technician to replace the
timer.
5-1
b. The condensers are dirty on 
air-cooled machines.
b. Clean condensers monthly.
7-1
c. The control switch is not in the
AUTO position.
c. Put the control switch into the AUTO
position for compressor operation.
5-1
4. There is excessive mix
leakage in the rear drip
tray.
a. The seal on the beater driveshaft is
missing or worn.
a. Install or replace the seal on the
beater driveshaft.
6-1/9-1
b. The rear shell bearing is worn. b. Contact service technician to replace
the bearing.
- - -
c. There is improper lubrication on
the beater drive shaft.
c. Lubricate properly. 6-1
5. The buzzer does not
sound when the
machine cycles off.
a. The buzzer is malfunctioning. a. Contact service technician to replace
the buzzer.
- - -

Taylor 104 Specifications

General

Brand	Taylor
Model	104
Category	Freezer
Language	English