15
Models 104 & 220
Controls
Start withfive minutesand increaseas needed. Times
and temperatures are dependent on specific mix
formulations, pre-charge amounts and finished
product preferences.
Note: Becausethefreezingcylinderforthe firstbatch
is at room temperature, the first batch freeze-down
time will be longer than subsequent batches.
Door Hinge
This feature allows the operator to open the door
without removal. This feature is primarily used when
changing flavors and clean-up is necessary.
Reset Condition
The Model 104 is equipped with an internal motor
overload protection. Should an overload occur, the
resetmechanismwilltrip,cancellingfreezeroperation.
Toproperlyresetthefreezer,putthecontrolswitchinto
the OFF position.Allow thebeater motortocool.Then
return the control switch to its original position.
Note: If the unit went out on reset, the product may
have been run too cold or too long. Therefore, after
resetting thefreezer,check thetemperature control or
time set.
To Next Page
Loading...
Need help?
General
