Taylor 8756 - Page 30

6-8
OPERATING PROCEDURES
Model 8756
Operating Procedures
6
9. Slide the O-ring into the groove on the mix inlet fitting
and lubricate the O-ring.
Figure 6-30
10. Insert the mix inlet fitting into the hole in the base of
the liquid valve body.
Figure 6-31
11. Secure the pump parts by sliding the keeper pin
through the holes at the bottom of the pump body.
Figure 6-32
12. Assemble the flare line and suction line. Attach the
suction line to the barbed end of the mix inlet fitting
and allow the weighted end to hang freely.
Attach one end of the flare line to the threaded fitting
on the lower side of the pump body. Allow the other
end to hang freely.
Figure 6-33
13. Place the pump collar over the pump body.
Note: The crossholes of the pump collar will be on top.
Figure 6-34
15047
Apply the appropriate
Taylor approved food safe lubricant.
15048
15049
15097
15022