Taylor C716 User Manual

56
Models C708 & C716Troubleshooting Guide
150623
PROBLEM PROBABLE CAUSE REMEDY PAGE
REF.
14. The drive shaft is stuck in
the drive coupling.
a. Mix and lubricant collected
in drive coupling.
a. Brush clean the rear shell
bearing area regularly.
50
b. Rounded corners of drive
shaft, drive coupling, or
both.
b. Call an authorized service
technician.
---
c. Gear box is out of
alignment.
c. Call an authorized service
technician.
---
15. The freezing cylinder
walls are scored.
a. Missing or worn front
bearing and beater shoes.
a. Install or replace the front
bearing and beater shoes.
34, 37
b. Scraper blades and/or
clips are damaged.
b. Replace scraper blades
and/or clips.
34
c. Unit was placed in AUTO
before all sanitizing
solution was removed
from freezing cylinder.
c. Place unit in AUTO only
after priming is complete
and all sanitizing solution
is removed.
43/ 44
d. Broken freezer door baffle
rod.
d. Replace freezer door.
37
e. Broken beater pins. e. Replace beater assembly.
34
f. Beater assembly is bent. f. Replace beater assembly.
34
g. Unit was placed in AUTO
before all sanitizing
solution was removed
from freezing cylinder.
g. Place unit in AUTO only
after priming is complete
and all sanitizing solution
is removed.
43 / 44
h. Gear box is out of
alignment.
h. Call an authorized service
technician.
---
16. The product makes a
popping sound when
drawn.
a. Draw rate is set too fast. a. Adjust draw rate of 5 to 7
1/2 oz. (142 g. to 213 g.)
of product by weight in 10
seconds.
19
b. Pump assembled
incorrectly.
b. Assemble and lubricate
according to instructions
in this manual.
39
c. Freezing cylinder not
primed correctly.
c. Drain the freezing cylinder
and reprime the machine.
44

Taylor C716 Specifications

General

Hopper Capacity	20 quarts (18.9 liters)
Separate Hopper Refrigeration (SHR)	Yes
Air Cooled	Yes
Freezing Cylinder	One
Mix Hopper	One
Electrical	208-230/60/1
Motor	1.5 HP
Indicator Lights	Mix Low
Refrigeration System	Air Cooled