Emergency update
Every device has the option to still upload the firmware if something went wrong during the normal update
procedure. For the devices with USB it is very simple. You just press and hold the bind button for the
diversity receiver or the joystick enter button for the transmitter while you plug in the USB cable. The
device will show up inside the TBS Agent and you have the ability to reload the firmware.
For the micro receiver it is a little bit more complicated. As the device itself does not have a USB connecter
the firmware needs to be loaded by BST for emergency update. This requires a TBS CORE PRO or a
diversity receiver. Connect the micro receiver to one of those devices by BST. Press and hold the bind
button of the micro receiver while powering up the TBS CORE PRO or the diversity receiver by USB. In case
of the diversity receiver you need to keep pressing the bind button while powering up the micro receiver
with an own power supply.
The LED of the micro receiver should blink fast which indicates the receiver is in bootloader mode.
Open your TBS Agent and load the latest version. Once the device connected directly to the USB is
updated, the TBS Agent will update the micro receiver too.
For further informations you can check this manual.
To Next Page
Loading...
