Creating loops
Ditto Stereo Looper English Manual 12
Stopping loop playback / recording
To stop loop playback, press the footswitch
twice in short succession.
To stop recording, press the footswitch once.
The LED will start flashing in green to indicate
that your loop is still in memory and ready for
playback.
Stopping loop playback / recording
and deleting the loop/backing track
To stop loop playback/recording and delete ev-
erything you have recorded, press the footswitch
twice in short succession and hold down your
foot on the second tap. Please note that it takes
three seconds until the backing track is actually
deleted.
The LED will turn off to indicate that the loop has
been deleted. At this point, you can start record-
ing loops from scratch again.
Deleting the loop when you are
not recording or playing back
To delete everything you have recorded (instead
of just removing the last take) when you are not
recording or playing back, press and hold the
footswitch.
! When you delete a loop by pressing and hold-
ing the footswitch, playback will start before
the loop is actually deleted. This simply can-
not be avoided, because hitting the footswitch
triggers playback before Ditto Stereo Looper
„realizes“ that you actually want to delete the
loop.
The LED will flicker red and then turn off to indi-
cate that the loop has been deleted.
When you delete your loop from Ditto Stereo
Looper, the device goes into True Bypass mode.
Other than clearing the last overdub (which
can be undone), deleting the full loop as de-
scribed in this section cannot be undone.
To Next Page
Loading...
Need help?
General
