Footswitch LED reference
Ditto Stereo Looper English Manual 17
Balancing backing track
and current loop levels
What you are recording with Ditto Stereo Looper
is called “the current loop”. If you store this cur-
rent loop (by using the Store / Backing track level
switch), or if you import a previously recorded
track from a computer as described in the previ-
ous section, this is a “backing track”.
You can set the volume for the current loop
and the backing track independently.
– To set the level of the current loop, turn the
LOOP LEVEL knob.
– To set the level of the stored backing track,
turn the LOOP LEVEL knob while pulling the
Store / Backing track level switch towards
you.
The ability to control the volume of the current
loop and the backing track independently allows
you to control the mix very effectively.
Bypass modes
Here at TC, we have a simply philosophy: When
you are using one of our products, you should
hear something great – and if you don’t, you
shouldn’t hear it at all. This is why this pedal
sports True Bypass. When it is bypassed, it is
really off and has zero influence on your tone, re-
sulting in optimum clarity and zero loss of high-
end. Also please note that the pedal lets your
dry, unprocessed sound pass without ever con-
verting it to digital – keeping your original tone
pure and without any latency.
Footswitch LED reference
Use this section as a reference when you are not
sure what the current LED status means.
Footswitch LED…
Off Device disconnected or no
loop in memory
Blinking green Loop in memory, playback/
recording stopped
Green Loop running (LED will blink
shortly when LOOP end is
reached)
Red Loop recording
Blinking red Loop currently being erased
or converted
To Next Page
Loading...
Need help?
General
