Getting support
Ditto Stereo Looper English Manual 20
Frequently asked questions
“Where should I place Ditto Stereo
Looper in my signal chain?”
To get the most out of your setup and the loops
you’re recording, place Ditto Stereo Looper at
the end of your signal chain. This gives you the
flexibility to add parts with or without signal pro-
cessing by simply switching effects on and off
as required. For more information, see Setup
examples.
“How much loop time can I get
out of Ditto Stereo Looper?”
Ditto Stereo Looper provides five minutes of
looping time.
“What’s the maximum number
of overdubs that I can record?”
Our guess is that you will tire out before Ditto
Stereo Looper does. Ditto Stereo Looper allows
an unlimited number of overdubs – so do your
worst!
“I made a mistake – how
do I undo a part?”
Press and hold the footswitch on Ditto Stereo
Looper while it is playing back your recorded
loop. The last part you recorded will be removed.
“The footswitch LED is blinking
orange, and I can’t play or
record. What gives?”
Your Ditto Stereo Looper is connected to a com-
puter via USB and running in USB transfer mode.
Make sure that no files are currently being trans-
ferred to or from Ditto Stereo Looper and remove
the USB cable to return to normal operation.
Getting support
As you have probably realized by now, Ditto Ste-
reo Looper offers a wealth of features, and you
may have questions that we didn’t cover in this
manual. To learn more about setups, importing
and exporting loops as backing tracks, creative
techniques etc., please go to the Ditto Stereo
Looper FAQ at
http://tcelectronic.com/ditto-stereo-looper/faq/
You will also find a link to this page in your Ditto
Stereo Looper’s folder when you have connect-
ed it to your computer.
If you still have questions about the product after
reading this manual and the FAQ page, please
get in touch with TC Support:
http://tcelectronic.com/support/
To Next Page
Loading...
