Teac AG-360 - TROUBLESHOOTING; Power Issues Troubleshooting; Amplifier Problems Troubleshooting; Tuner Reception Issues Troubleshooting

TROUBLESHOOTING
To determine any problem with your receiver, always check the most obvious possible causes first. If any problem
still remains even after you have checked the items below, consult your nearest TEAC dealer.
Problem
Probable Cause
Remedy
No power Power cord is not plugged in. Plug in the power cord securely.
Amplifier
Sound cannot be heard.
The required Function Selector
Button is not ON.
Set the required Function Selector
Button to ON.
Connection to speaker system is
incorrect.
Check connections.
The TAPE MONITOR button is ON.
Set the TAPE MONITOR button to
OFF.
Sound is only heard from one
channel.
The BALANCE control is set to one
end.
Adjust the BALANCE control.
No sound from the rear speakers.
Speaker is connected to only one
channel.
Connect each speaker to both
channels (L and R).
Low-frequencies are insufficient and
the image of mid-frequencies is not
fixed.
The plus and minus connections of
either front speaker are reversed.
Connect the speakers with the
correct polarities.
Hum or noise.
Turntable is not grounded.
Connect the ground wire to the
GND terminal on the rear panel.
Audio equipment is too near the TV.
Move the TV away from the audio
equipment.
Tuner
No tuning. The antenna is not connected. Connect the antenna.
Auto tuning not possible. Signal strength of stations is too
weak.
Perform manual tuning.
Use a better external antenna and
adjust its direction.
STEREO indicator fails to light
during stereo broadcasts.
The FM MODE button is set to Mono
mode.
Set the FM MODE button to Stereo
mode.
Electromagnetic interference.
Caution:
Ignition noise from cars.
Use the external antenna and install
it away from the street.
TV too near the receiver.
Move the receiver away from the
Tv.
Since the unit incorporates a microcomputer, it may not operate correctly because of external noise, etc. If this happens,
turn the power switch OFF, then turn it ON again and restart operations.
=