Teac AG-360 - Speaker Connections; Connecting Speakers to Receiver; Speaker Placement Guidance

@ AM Outdoor Antenna
If the AM loop antenna provided does not deliver
sufficient reception (because you are too far from the
transmitter or in a concrete building, etc.), it may be
necessary to use an outdoor AM antenna. Use an
insulated wire more than 15 ft (5 m) long, strip one
end, and connect this to the terminal as shown. The
antenna wire should be strung outdoors or indoors
near a window. For better reception, connect the
GND terminal to a reliable ground.
Note: Even when using an outdoor AM antenna, do
not disconnect the AM loop antenna.
AM Outdoor
Antenna
AM Loop Antenna
(provided)
How to connect antenna
Press the lever down and insert the stripped
end of the wire into the correct hole. Then
release the lever so that the wire is held
securely.
[ Speak
Caution:
To avoid damaging the speakers by inputting a
sudden high-level signal, be sure to switch the power
off before connecting the speakers.
Connect each speaker to the corresponding speaker
terminals, as desired.
Notes:
e@ When using the rear speakers, be sure to connect
them to both channels (L and R). If a speaker is
connected to only one channel, no sound will be
heard.
@ Use speakers with a nominal impedance of 8 ohms
or more.
How to connect speaker cords
Press the lever, insert the stripped end of the
cord, then release the lever so that the cord is
held securely.
Speaker Installation
Place the speakers where the sound seems best to you.
Your receiver enables you to listen to the surround
sounds using two pairs of speakers.
TV Monitor
Front (L) Front (R)
‘a
Rear ~ YS Rear (R)