Teac AG-360 - PRECAUTIONS; Unit Placement Advice; Voltage Conversion Procedure; USA FCC Compliance and Interference

PRECAUTIONS
As the unit incorporates a powerful amplifier, heat is
radiated from the back and top of the unit; the
location where the unit is installed should be well
ventilated. Avoid installing where it would be exposed
to high temperatures, direct sunlight, high humidity
and dust. If the wiring is too long, particularly the
speaker cables, it may result in degraded sound. Keep
the connection cables as short as possible.
-- VOLTAGE CONVERSION
For General Export Models
Be sure to remove the power cord from the AC
outlet before repositioning the voltage converter
switch.
1. Locate the voltage selector on the rear panel.
2. Using a flat-bladed screwdriver, set to the
appropriate 115 V or 230 V position according
to your area.
VOLTAGE SELECTOR
115V _-230V
sebeee. ‘pemmeene
Lo)
r-For U.S.A
TO THE USER
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable
protection against interference in a residential
area. This device generates and uses radio
frequency energy and if not installed and used in
accordance with the instructions, it may cause
interference to radio or TV reception. If this unit
does cause interference with TV or radio
reception you can try to correct the interference
by one or more of the following measures:
a) Reorient or relocate the receiving antenna.
b) Increase the separation between the
equipment and the receiver.
c) Plug the equipment into a different outlet so
that it is not on the same circuit as the
receiver.
If necessary, consult the dealer or an experienced
radio/TV technician for additional suggestions.
CAUTION
Changes or modifications to this equipment not
expressly approved by TEAC CORPORATION for
compliance could void the user's authority to
operate this equipment.
For CANADA
AC POWER CORD CONNECTION
CAUTION:
TO PREVENT ELECTRIC SHOCK, MATCH WIDE
BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.
ie For CANADA
THIS DIGITAL APPARATUS DOES NOT EXCEED
THE CLASS B LIMITS FOR RADIO NOISE
EMISSIONS FROM DIGITAL APPARATUS AS SET
OUT IN THE RADIO INTERFERENCE
REGULATIONS OF THE CANADIAN DEPART-
MENT OF COMMUNICATIONS.