User’s Manual
12
Note: Batteries, including those which contain no heavy metals, may not be disposed of
with household waste. Please dispose of used batteries in an environmentally sound
manner. Find out about the legal regulations which apply in your area.
2.3 Power on
1. Connect one end of power adaptor to the receiver.
2. Connect the other end of power adaptor to wall outlet.
3. Turn on the unit, system initializes and start-up OSD is shown on TV screen.
Note: Please turn on your TV and switch it to AV mode.
2.4 Power on and check picture
1. If there are some channels stored in the unit, after initialization, program will be played
automatically, and the channel number is shown on front panel DISPLAY.
2. If there is no channel stored in the unit, after initialization, system will search channels
automatically. Refer to 7.2 Search Type for more search details.
2.5 Active Standby & Passive Standby
The unit supports two standby modes:
v ACTIVE Standby
v PASSIVE Standby
To turn off unit, press STB POWER key on the
remote control or front panel, there will be a win-
dow pop up with 2 selections. You can press
keys to select Active Standby or Passive Standby
and press OK key to confirm. If you don’t make a
selection, then the highlighted option will take
effect and the unit will turn off after 10 seconds.
In Active Standby Mode:
1. Antenna LOOP OUT connector on the rear panel will still output antenna signal.
2. The current time will be showed on the front panel VFD display, as show below.
To Next Page
Loading...
General