TEC EM1-31064 - Page 48

11-22
11. PROGRAMMING PROCEDURES
EM1-31064
11.12 CMT/PL-3
Table4 : Transmission Item List
NOTE: When the PL-3, required FDK varies depending on the volume of ING data.
Be careful of the following when changing a FDK.
a: During the write operation, replace the FDK with a formatted one.
b: Verify and read data in the same order as the write.
To cancel to change a FDK, press the
CLEAR key.
ITEM # Contents of Transmission CMT PL-3Title on the Display
2 VERIFY PLU & ING = CMT 2 COMPARE PLU & ING. IN OLD FORMAT
READ PLU & ING. FM CMT 3 READ PLU & ING. IN OLD FORMAT
WRITE PLU TO CMT 4 SAVE PLU IN NEW FORMAT
VERIFY PLU = CMT 5 COMPARE PLU IN NEW FORMAT
READ PLU FM CMT 6 READ PLU IN NEW FORMAT
WRITE ING TO CMT 7 SAVE ING. IN NEW FORMAT
VERIFY ING = CMT 8 COMPARE ING. IN NEW FORMAT
READ ING. FROM CMT 9 READ ING. IN NEW FORMAT
WRITE NUTRI. TO CMT 10 SAVE NUTRITION IN NEW FORMAT
VERIFY NUTRI = CMT 11 COMPARE NUTRITION IN NEW FORMAT
READ NUTRI. FM CMT 12 READ NUTRITION IN NEW FORMAT
WRITE SPEED KEY 13 SAVE SPEED KEY IN NEW FORMAT
VERIFY SPEED KEY 14 COMPARE SPEED KEY IN NEW FORMAT
READ SPEED KEY 15 READ SPEED KEY IN NEW FORMAT
3
4
5
6
7
8
9
10
11
12
13
14
15
: operable, : inoperable