45
In the CI module NMS interface, there are four items for user to select/configure. Only after the
parameters are correctly set can the CI module work normally.
Indicates which CAM the user is operating.
The TSClock is selected according to the CAM and actual bitrate of
input TS.
Five options in the TSClock can be selected:
9MHz--support up to 72Mbit input TS.
9.5MHz--support up to 76Mbit input TS.
10.5MHz--support up to 84Mbit input TS.
11.5MHz--support up to 92Mbit input TS.
13MHz--support up to 104Mbit input TS.
！Please select default 9MHz for the TSClock if input TS is less
than 72Mbit in total bitrate.
To set a fixed output bitrate for the CI module. It will take effect when
user selects the CBR mode.
！Please set a bigger bitrate value than the input TS rate and
reserve a bit buffer.
After setting all the parameters, you should press ‘Apply’ button to save the settings.
Descramble Operation Procedure:
Note:
1. The descramble function needs the support of a CI descrambling module.
2. The inserted CAM should be able to support the CAS of the scrambling program.
3. User needs to have a valid authorized smart card (same CAS type as the scrambling
program) to work with the CAM.
1. Select a scrambling program of a receiving module in the input window and transfer it
to the corresponding CI module port (port 1 or 2) in the output window. The EMM data
of the scrambling program must be transferred at the same time.
Note: To avoid any SI problem, it is recommended to use “Bypass” mode when
transfer the program to CI module, following content will describe the operation:
To Next Page
Loading...