Technalogix TP1000 - Page 71

71
Video PID
To edit the Video PID.
PMT PID
To edit the PMT PID.
Service ID
To edit the service ID.
Provider Name
To edit the service provider name.
Program Name
To edit the channel name.
After setting all the parameters, you should press ‘Apply’ button to save the settings.
 Status
Go to “Status” tab and check the module running status. The parameters of this part are derived
from the input signal; they will be gotten automatically when the input signal is available, and
cannot be changed by the user.
Pic-3.1-68
 3.2.4.15 Low Bitrate H.264/MPEG-2 SD Transcoder Module
The low bitrate SD transcoder module supports transforming 2 HD or 4 SD channels to
MPEG-2 or H.264 SD format in very low bit rate simultaneously.
Parameters
Description
Port#(T)
Indicates the total bit rate of input signal, including the valid and null
packet. The unit is Mbps
Port#(E)
Indicates the bit rate of valid packet (excluding the null packet). The
unit is Mbps.
Video Resolution
the resolution of input video