Enable the SNMP function. Use the corresponding software tool (MIB Builder and MG-
SOFT MIB Browser. You still need two MIB file: BASE-SNMP-MIB, DVR-SNMP-MIB) to
connect to the device. Get the device corresponding configuration information after
successfully connection. Follow the steps listed below to configure.
Check the box to enable the SNMP function. Input the IP address of the PC than is
running the software in the Trap address. Use default setup for the rest items.
Compile the above mentioned two MIB file via the software MIB Builder.
Run MG-SOFT MIB Browser to load the file from the previous step to the software.
Input the device IP you want to manage in the MG-SOFT MIB Browser. Set the
corresponding version for your future reference.
Open the tree list on the MG-SOFT MIB Browser; get the device configuration. See
how many video channels, audio channels, application version and etc. the device
has.
Note: Port conflict occurs when SNMP port and Trap port are the same.
H: Bonjour
After you enabled the Bonjour function, the OS or the client-end that supports the Bonjour
function can automatically detect the IP camera. View the server name when the IPC is
detected by the Bonjour. Note the Safari browse support this function. Click the “Display All
Bookmarks: and open the Bonjour, system can auto detect the IPC of the Bonjour function
in the LAN.
I: Multicast
Multicast is a transmission mode of data package. When there is multiple-host to receive
the same data packet, multiple-cast is the best option to reduce the broad width and the
CPU load. The source host can just send out one data to transit. This function also depends
on the relationship of the group member and group of the outer. For detail information refer
the help file on web interface!
J: WIFI
J.A: WIFI
Check the box to enable WIFI function and then click the Search SSID button. Now you can
view all the wireless network hotspot information in a list. Click on the SSID of your choice.
See the signal quality and the authentication mode. Note sometimes you need to input the
password. For detail information refer to the help file!
To Next Page
Loading...
Need help?
General
