J.B: WPS (only TX-65 & TX-66)
To connect the camera via WPS you have to enter the Pin and the SSID of your router.
Find these information’s in the configuration of the router.
You also can connect the camera with the router by pressing the Network button on the
camera and the WPS button at your router.
K: 802.1x (Only TX-67)
802.1x works standing for local and metropolitan area networks and port based network
access control protocol. It supports manual operation of the client to choose means of
authenticating by which to control it to access to the Local Area Networks or not. It supports
the ability to authenticate, to calculate fee, to ensure security and to maintain requirements.
L: QoS
DSCP priority has 64(0-63) levels. It marks the different priorities of the packets. Level 0
has the lowest priority and level 63rd has the highest priority. It can select the different
queues according to the priorities of the packets and select the bandwidth of each queue. It
can also discard at the different ratio when the broad bandwidth is jam.
6.6.4 PTZ
The PTZ interface is shown in Figure 6-12. Here you can adjust and set Preset, Tour, Scan,
Pattern, PTZ Speed, etc.
Figure 6-12
To Next Page
Loading...
Need help?
General
