Record: Check the box here, system auto activates motion detection channel(s) to
record once an alarm occurs.
Record Delay: System can delay the record for specified time after alarm ended. The
value ranges from 10s to 300s.
Send email: Check the box here, ystem can send out email to alert you when an alarm
occurs.
PTZ (Only TX-67): Set PTZ movement here when an alarm occurs. Such as go to
preset, tour & pattern when there is an alarm.
Snapshot: Enable this function to snapshoot image when a motion detect alarm occurs.
For detail information refer the help file.
6.6.5.2 Abnormality
A: MicroSD Card (only when MicroSD Card is inserted)
Enable: Check the box here to enable abnormality of MicroSD Card.
It includes the status: No MicroSD card, MicroSD card error and capacity warning.
Check “Send Email” to get an event via Email.
B: Network
Enable: Check the box here to enable abnormality of Network.
It includes the status: Disconnection and IP conflict. Check “Record” to get an event
recorded.
Record Delay: System can delay the record for specified time after alarm ended. The value
ranges from 10s to 300s.
C: Illegal Access
Enable: Check the box here to enable abnormality of Illegal Access.
Under “Login Error” set the amount of unauthorized access (3-10 times).
Check “Send Email” to get an event via Email.
6.6.6 Storage
6.6.6.1 Schedule
In the schedule interface, you can add/remove three types of record plan or snapshot plan.
There are six periods in one day. System cannot enable the record function in the specified
period if the record function is disabled in the record control interface. View the current time
period setup from the color bar.
To Next Page
Loading...
Need help?
General
