Technicolor CGM4231 - SNMP Provisioning for Service Filter; VPN Settings; User Provisioning for VPN Settings

1/8/2018 Proprietary and Confidential - Technicolor 77
8.5.1 SNMP Provisioning for Service Filter
Following MIBs implements the Service Filter functions:
• tchRgFirewallPortFilterIndex - Main Index
• tchRgFirewallPortFilterRowStatus - To Add/delete and view the rows
• tchRgFirewallPortFilterPortStart - To set Start Port Number
• tchRgFirewallPortFilterPortEnd - To set End Port Number
• tchRgFirewallPortFilterProto - To set the desired Protocol
• tchRgFirewallPortFilterAlwaysBlock - To set permission to always block
• tchRgFirewallPortFilterBlockStartTime - To Set the Start time of the Time Interval
Based blocking
• tchRgFirewallPortFilterBlockEndTime - To set the End time of the Time Interval based
blocking
• tchRgFirewallPortFilterBlockDays - To Set the Days filter for Day based blocking
8.6 VPN Settings
This feature is used in cases where the Wireless Gateway acts as the VPN end point and all the
machines connected to the LAN side want to be on the enterprise private network. This is mainly
used in B2B (Business-2-Business) applications.
For the Wireless Gateway to act as a VPN end point, the user needs to configure a VPN tunnel
on the Wireless Gateway. This can be done from the Security / VPN page. Enter the details of
the local subnet and the remote subnet including the VPN gateway and security parameters for
IPSEC (Key Exchange Method, Encryption, Authentication, Pre-shared key. etc.). Obtain these
details from the network administrator (of the enterprise you are connecting to) before setting up
the VPN tunnel.
8.6.1 User Provisioning for VPN Settings
Security Tab / VPN
Click on Security tab then click on VPN tab. The page displays VPN setup information. Here the
user can set and display VPN information.