Technics RS-DC10

AN ats (ole fa ja|ele iam (=1e,6) cela (6m (BO. Om F-le!-\-))
Recording from the start of a tape
Refer to page 38 for recording from midway through a Preparations:
tape (append recording). ae 1. Check that the “accidental erasure prevention tab”
Upon completion of recording on side A, the recording on the DCC tape for recording is set to the
side is automatically switched to B and recording recording position. (See page 11.)
continues. : 2. Load the cassette tape. (See page 17.)
1 a
1
a 1
’ 4 t 1 1 1 1
’
Technics carat couact casserre peck ms-acts
J
SPELT Tree TTS
1 aaa Set the input
o~é selector to
© “ANALOG”.
2 REW Check that the side to be Even If the tape is new, be sure to rewind it first so that the
aq recorded is side A, and absolute time will be written.
rewind the tape to Do not operate any other button until the tape automatically
its beginning. comes to a stop after rewinding.
3 Set the deck to the Writing the lead-in
REC: is
recording standby f
mode.
H
After the lead-in has been
written onto the tape, the
deck is set to the
recording standby mode.
This takes about
30 seconds.
{See page 32.)
The recording Indicator
lights and the play | -rnack- —1mercounren— ——~ mooe——
indicator flashes. The H :
analog input indicator
lights.
Recording standby mode »