Technics RS-DC10

Various Recording Methods (DCC Tapes)
3 Check the append recording position.
After playing back the last 10 seconds of the last
track, the deck is set to the recording standby mode
with the number following the number of the last track.
Position where previous
recording was stopped
(where the use again marker
was written)
@ Search the append
recording position. oS
¥
@ The last 10 seconds
of the last track is
played back.
Number of new track
Number of last to be recorded (15)
track (14)
@® The deck is set to the recording
standby mode at this position.
TRACK=
TIME; COUNTER —
(REG PAUSE)
The number of the new track to be recorded appears here.
When several use again markers have been written
on the tape, the deck is set to the recording standby
mode where the first of these markers is written.
If the tape position is not where the
recording is to start
When the append button is pressed again while the
last 10 seconds of the last track are being played or
while the deck is in the recording standby mode, the
position of the next use again marker written on the
tape is searched.
Bear In mind that in the following case the deck will be
set to the recording standby mode at the beginning of
the tape.
“1” appears to denote track No. 1.
1. When the append button was pressed at the
leader tape section:
(——— Beginning of tape
Tape
ti Leader tape section
2. When the position where the previous recording
was stopped could not be searched because of
the tape travel mode.
(with lengthy unrecorded parts on the tape)
In this case, the search changes to side A after
side B is searched, and after the first 10 seconds
of the first track have been played back, the. deck
is set to the recording standby mode.
In cases 1 and 2, press the append button again, and
check that the unit is set to the recording standby
mode at the number of the track following the last
track.
3. When no use again markers have been written on
the tape:
In this case, the append recording function cannot
be used.
4 AUTO Select the track
number writing
mode.
This button selects
automatic or manual track —
number writing.
5 Start the recording.
With digital inputs:
Perform step 5 of “Digital Input Recording” (see
pages 30 and 31).
With analog inputs:
Perform steps 5 to 7 of “Analog Input
Recording” (see pages 34 and 35).
References:
The input source can be monitored In the recording
_Standby mode.
With a tape which has been recorded up to the end of side
B, the search changes to side A after searching side B,
the first 10 seconds of the first track are played back, and
the unit stops at the beginning of the tape.
KE