Technics RS-DC10

Various Recording Methods (DCC Tapes)
Recording from midway through a tape
(append recording)
The absolute time written may not be accurate if the
append recording is conducted after the tape is fast
forwarded or rewound, The append recdérding function
makes it possible to search the position of the use
again marker (see page 42) written on the tape and
set the deck to the recording standby mode.
When append recording is performed using this
method described below, no unrecorded parts will
Temain on the tape, and the absolute time can be
recorded uninterrupted.
Preparations:
1. Check that the “accidental erasure prevention tab”
on the DCC tape for recording is set to the
recording position. (See page 11.)
2. Load the cassette tape. (See page 17.)
Select the Input
source.
1 INPUT SELECTOR
ANALOG,» OPTICAL
©
Search the position
where append
recording Is to be
performed.
The following procedures
will be performed
automatically.
{1) Search the position where the previous
recording ended.
(2) Play back the last 10 seconds or so of the
track.
(3) The recording standby mode is established.