Technics RS-DC10

Types of Sub Codes for Editing and Their Functions
Editing of start markers and track numbers
Editing item Description of editing
: Automatic writing
]
During recording, the start
markers and track numbers
are automatically written in
numerical order. = __
Recording with digitally input signals:
The start markers and track numbers are
written when the signals indicating where
the tracks begin are included among the
i tape.
digital signals supplied to the deck. 82
(Signals indicating where each track
begins are not output from CD players,
some DAT models or BS tuners.)
i Recording with analog input signals:
: They are written after an unrecorded blank
j section (level of —60 dB or below) lasting 36
: about 3 or more seconds when the sound
begins to re-appear.
Manual writing Start makers can be recorded manually at any desired position while the tape 48
is being played back.
Erasing start markers | The start markers and track numbers which have been written can be erased 49
and track numbers if so required.
Renumbering of When start markers have been rewritten, for instance, the tracks can be
tracks ! automatically renumbered in the right sequence from the beginning of the 50
In the case of a DCC tape for recording, the track numbers may not appear on the display if playback is started
from any point in a track.