Technics RS-DC10

yA
Types of Sub Codes for Editing and Their Functions
Markers for editing
T
Type of sub code Main function | Description =.
ae a
Reverse marker: When there is not enough The side B track numbers and absolute i
This serves to change | tape remaining on side A to time are written as continuations of those =| 45, 49
from tape side A to enable the next track to be on side A. \
! side B at any point on recorded in its entirety, the + —
i side A. recording this next track can When the reverse marker has been written
be continued on side B. ; during recording, it will be written
The recording of the track can | temporarily on side B. Upon completion of i
1 be continued on side B even the recording, be absolutely sure to | 50-51
; from any point on that side | renumber the tracks and rewrite the
without interrupting the | marker properly on side A. |
recording. | H
i = a aa
Next marker: : This is convenient for The first track on side B is written as
This is used to : recording separate albums on_ | track 1, and the absolute time is written
change over from any |; sides A and B. starting from 0:00.
point on side A to the 47, 49,
beginning of side B or Py 3
to change over from
any point on side B to
the beginning of side
i ta.
Absolute time and append recording
a ]
Type of sub cod: Main function i Description Page |
ype of sub code | lain tunctio: \ scriptio! no. |
nae sa Pal
Absolute time: This comes in handy for : The absolute time may not be written |
This Indicates the checking the tape position or = properly if the tape is fast forwarded or
amount of time which for searching a particular rewound for performing append recording.
has elapsed from the position on a tape accurately. When recording from any point along a 18, 38
start of the tape. Itis =; tape, proceed with recording using the :
; required to display the append button. (The approximate time is |
time and track ! : shown while the tape is being fast
numbers. i | forwarded or rewound.}
Use again marker: This comes In handy when ; When the append button is pressed, the
This indicates the finding the end of a previous position where the previous recording was
: position where the tecording and appending new stopped (where the use again marker was i
| previous recording ; material. written) is searched and the unit is set to 31, |
was stopped. It is the recording standby mode. 38~39,;
automatically written =| 49
| at the position where |
| the recording is
| stopped. |