Technics RS-DC10

Marker Editing after Recording
2
Auto track number
write button
Writing the start marker manually
The start marker can be written at any position while
the tape is playing back.
Preparation:
Check that the “accidental erasure prevention tab” on
the DCC tape for editing is set to the recording position.
(See page 11.)
While playing back the tape,
locate the position where the
recording Is to commence.
WRITE
marker.
The start marker is written
at the position on the tape
where the button is
pressed.
MopE Patio oe
Fa START, This lights
H \ for about
‘ mu 1} 3 seconds.
7
“see
3 Repeat steps 1 and 2 to write another
start marker.
ere ee
©The start marker cannot be written onto prerecorded DCC
music tapes.
When an unnecessary start marker has been written, first
” “Yewirid the tape fo a position immediately before the start
marker, erase it, and then write the marker by pressing the
manual track number write button at the position where the
marker Is to be written.
When the start marker has been written manually, the
sequence of tracks changes. Proceed with renumbering ___.
“"€886
page
SOV
TS
allocate
new
numbers
fo
the
tracks.
aren ae aes=
on ee ng TIRE RRR Oe me SE TEI Se ea Ae ATEN