Technics SA-EX320 Operating Instructions

FM outdoor antenna
(not included)
75 О coaxial cable
(not included)
@ Remove a piece of the outer
vinyl insulator.
ERE LL.
20 mm (25/32")
(2 Twist the shield braid
to expose the core
wire.
мот
Shield braid 10 mm (3/8")
(3 Connect the shield braid and the
core wire as shown at the left.
Core wire
Vinyl-covered wire
(not included)
AM loop antenna
(included)
Antenna
connections
|
FM outdoor antenna (not included)
An outdoor antenna should be used when using this unit in moun-
tainous areas or in spaces enclosed by reinforced concrete where
the FM indoor antenna (included) does not provide satisfactory
reception.
Disconnect the FM indoor antenna if an FM outdoor antenna is
installed,
An outdoor antenna should be installed by a qualified technician
only.
AM outdoor antenna (not included)
An outdoor antenna should be used when using this unit in
mountainous areas or in spaces enclosed by reinforced concrete
where the AM loop antenna (included) does not provide satisfactory
reception.
Stretch 5-12 m (16-40 ft.) of vinyl-covered wire horizontally across
a window frame or other convenient location, keeping it as high as
possible from the ground.
When the unit is not in use, disconnect the outdoor antenna to
prevent possible damage that may be caused by lightning. Never
use an outdoor antenna during an electrical storm.
Be sure to connect the AM loop antenna even when an outdoor
antenna is used.

Technics SA-EX320 Specifications

General

Tuning Range	FM, MW
Total Harmonic Distortion	0.08%
Signal to Noise Ratio	80 dB (MM)
Speaker Load Impedance	8Ω to 16Ω
Input Sensitivity/Impedance	2.5mV/47kΩ (MM)
Speaker Impedance	6 Ω - 16 Ω