Technics SA-EX320 Operating Instructions

н н наа ааа ааыа ат Ааа аьаа ла а а ааа ааыа е. АА у
ал іг
ГІ. 13
cy а
LES 1
.агвввееооетеоеосетеоетааФтаФтоаагевае жағааеааеваьнагаенавичевтчеттете Фе етиееоевеее
Listening to radio broadcasts |
ere, — qud
Sequential tuning п
You can use the tuning buttons to tune-in radio stations.
.......
Press TUNER.
Press BAND to select “FM” or “AM”.
Press TUNING (V) or (A) to tune to the
desired frequency.
Tuning intervals FM: 0.2 MHz
AM: 10 kHz
"QUARTZ LOCK” lights up when tuned.
"STEREO" lights up when an FM stereo broadcast is
received.
To make an automatic search for broadcast stations
If TUNING (V) or (^) is held down for an instant until the fre-
quency begins to scroll, the broadcast stations can be tuned
in automatically when a broadcast station is found.
Tuning may stop automatically if any jamming is encountered.
%%%8%е%%ФтаФааееааевееваеанивиекненавичеввчевтетейобе0е%00990064086909800е0606е»
If noise is excessive in the FM stereo mode
Press FM AUTO/MONO.
(The “STEREO” indicator will go out, and the “MONO?” indicator will
light up.)
The broadcast will be monaural, but noise will be reduced.
If the button is pressed once more, the stereo mode will be
resumed.
Direct tuning E
(Only available from the remote control.)
Specify the frequency using the numeric buttons on the remote
control transmitter to directly tune to the desired station.
First select between FM and AM with the BAND button on the
receiver.
1
Press TUNER.
This will set the remote control to operate the tuner.
Press DIRECT TUNING/DISC ENTER.
Press the appropriate numeric buttons to
enter the frequency, while cursor display is
flashing.
Tuning intervals ЕМ: 0.1 MHz
АМ: 10 kHz
if the desired FM frequency is 107.9 MHz, press
[1]— e o- 19)
If the frequency has been input correctly, the displayed
frequency will blink once.
1. If no button is pressed while the cursor display is flashing,
the display will return to the frequency which is currently
being received. To re-specify the frequency, repeat the
procedure from step 2.
2. If the frequency has not been input correctly, “ERROR”
indication will be displayed. In this case, re-enter the
frequency.
Operation mE

Technics SA-EX320 Specifications

General

Tuning Range	FM, MW
Total Harmonic Distortion	0.08%
Signal to Noise Ratio	80 dB (MM)
Speaker Load Impedance	8Ω to 16Ω
Input Sensitivity/Impedance	2.5mV/47kΩ (MM)
Speaker Impedance	6 Ω - 16 Ω