Technics SA-EX320 Operating Instructions

Operation e
|
-HELP
-НЕЗЕТ
About the HELP function
If you make a mistake in operation or if sound output stops due to
some operation which was performed, the HELP function displays
information which can be useful for indicating the method by which
this condition can be remedied.
If "ERROR" or scrolling characters (for instance, “TAPE MONITOR
ON NOW”) appear on the display during operation, carry out the fol-
lowing operation.
Press -HELP.
(Touch only.)
The method for remedying this situation will be displayed.
For your reference
If the above button is pressed for 2 seconds or more until "RESET"
appears on the display, the operation settings for the unit will be ini-
tialized to the settings made at the time of shipment.
However, any broadcasting stations which have been preset into
memory will not be erased at this time.

Technics SA-EX320 Specifications

General

Tuning Range	FM, MW
Total Harmonic Distortion	0.08%
Signal to Noise Ratio	80 dB (MM)
Speaker Load Impedance	8Ω to 16Ω
Input Sensitivity/Impedance	2.5mV/47kΩ (MM)
Speaker Impedance	6 Ω - 16 Ω