Power consumption in standby mode.
>
You can then start the WLAN network wizard and set up an Internet
connection.
>
Select [Yes] to start the WLAN network wizard.
Select [Yes (WPS)] to start the connection with WPS (only if supported by the
network router).
Select [No] to set up the network connection at a later time.
>
If you have selected [Yes], a list appears with the Wi-Fi networks within
range. Use the scroll wheel to select your Wi-Fi network and press the
scroll wheel to confirm.
>
Password entry
To enter the password, proceed as follows: The first digit is highlighted. Now
turn the scroll wheel until the first digit or letter of your password is
displayed. Press the button
▶ to accept the number or letter and skip to the next entry. Now proceed as
described above until the complete password has been entered. Press the
scroll wheel to connect.
To Next Page
Loading...
