41
2.2 Switching on and off
To turn the equipment on, switch the
switch to the “I” position.
When switched on, a beep sounds and
all the control panel LEDs light up.
After a quick system check and reset, the
equipment is ready for use.
2.2 Switching on and off
choose training
02226011
02258006
The message does not appear if the keys
are disabled (see section 3.12) so that
exercises can be started only with the
TGS key.
insert the TGS key
In this mode, the following functions are enabled:
- calculation of heart rate, if measured;
- reading of access codes for configuration menu (see section 3.12).
The message does not appear if the TGS
key reader is not installed or if the use of
the TGS key is disabled (see section 3.12)
so that exercises can be started only with
the control panel keys.
0SM00198AA_Bike Forma_02_UK.p65 01/07/2003, 17.4241