8. Ensure that clutch clearance is as specified. If necessary, adjust the
clearance using shims. Specified clearance is 0.01 to 0.02 in. (0.3 to
0.6mm)
Electrical Connection
1. Connect the lead wire to the electrical circuit.
2. Engage and disengage the clutch several times to check the clutch
engagement. The disc should snap firmly against the pulley.
Compressor Front seal Removal and Installation
Removal
1. Remove the clutch as outlined in Clutch Removal.
2. Remove the felt pad.
3. Use the seal remover to remove the shaft seal cover. Turn the seal
remover to engage on the hook on the seal remover with the hook on the
shaft seal cover, and then slowly pull the seal cover out of the cylinder
head.
Note: The shaft seal cover should never be reused, always replace the
cover with new one.
To Next Page
Loading...