S.p.A. ITEM TE550 Instruction manual
63/92
NOTES FOR THE SEAM WELDING WORKING MODE ONLY:
The welding currents set in the POWER 3 and CURRENT 3 parameters can be recalled
by means of the closing of RIC5 (Pin12) input.
The external recalls RIC5, RIC6 and RIC7 are not activated in the function of recall from
an external device program.
When the SEAM WELD MODE is set to ON, the butt welding (BUTT WELD MODE) and
high speed welding (SER. SPOT MODE) functions are disabled. Should one activate
them, this will make a programming error be displayed.
To Next Page
Loading...
