TECNA S.p.A. ITEM TE700 Instruction Manual
3/128
TABLE OF CONTENTS
CHAPTER 1 - TE700 WELDING CONTROL UNIT DESCRIPTION Pag. 6
1.1 - MAIN TECHNICAL FEATURES Pag. 7
1.2 - PANEL CONTROLS Pag. 8
1.3 - PANEL LEDs Pag. 9
1.4 - DESCRIPTION OF DISPLAYED INFORMATION Pag. 10
1.5 - CONTROL UNIT SWITCH-ON Pag. 18
CHAPTER 2 - CONTROL UNIT PROGRAMMING Pag. 20
2.1 - PROGRAM DATA Pag. 21
2.2 - CONSTANT CURRENT OPERATING MODE Pag. 23
2.3 - FIX OPERATING MODE Pag. 27
2.4 - CONSTANT SECONDARY VOLTAGE OPERATING MODE Pag. 31
2.5 - CONSTANT POWER OPERATING MODE Pag. 34
2.6 - CONSTANT ENERGY OPERATING MODE Pag. 37
2.7 - DYINAMIC COMPENSATION OPERATING MODE Pag. 41
2.8 - WORKING PROGRAM PARAMETERS DESCRIPTION Pag. 44
2.9 - SETUP MENU Pag. 54
2.10 - STEPPER MENU Pag. 57
2.11 - ADJUSTMENT STEPPER FUNCTION Pag. 61
2.12 - FEATURES TE700 Pag. 66
2.13 - FEATURES INVERTER Pag. 70
2.14 - PROGRAMS COPY Pag. 75
2.15 - CHECK INPUT – DIAGNOSTIC TE700 Pag. 77
2.16 - CHECK INPUT – DIAGNOSTIC INVERTER Pag. 78
2.17 - PROG. SEQUENCE Pag. 79
2.18 - THICKNESS SENSE Pag. 82
2.19 - TIP-DRESSING Pag. 86
CHAPTER 3 - SEAM WELD OPERATING MODE Pag. 91
CHAPTER 4 - CASCADE OPERATING MODE Pag. 97
CHAPTER 5 - THE WORK CYCLE Pag. 98
CHAPTER 6 - STOP BAD SPOTS Pag. 99
To Next Page
Loading...
