TECNA S.p.A. ITEM TE700 Instruction Manual
2.14 - PROGRAMS COPY
-TE700 VER. 1.13--
FEATURES TE700
FEATURES INVERTER
>PROGRAM COPY
This menu is used for copying the values of the parameters of a program to other programs
without having to set one parameter at a time (to make programming quicker).
PROGRAM COPY
>SOURCE PROGRAM. 003
COPY FROM PRG. 006
TO PROGRAM 010
After having selected the source program and the programs which it is to be saved in, simply
press the ¼ key and a request will appear asking either to continue and copy or cancel the
operation.
COPY PROGRAM?
<+> OK <-> CANCEL
In order to copy, simply press key <+> and the following screen is displayed. The bar shows
the copying progress state.
PROGRAM COPY WAIT…
▌▌▌▌▌▌▌▌▌
When the copying procedure is finished, the main programming screen is displayed.
-TE700 VER. 1.09--
FEATURES TE700
FEATURES INVERTER
>PROGRAM COPY
PROGRAM COPY MENU PARAMETERS TABLE
PARAMETER PARAMETER DESCRIPTION RANGE VALUE
SOURCE PROGRAM Source program 001 – 300
COPY FROM PRG Start copy/target program 001 – 300
TO PROGRAM Copy end program 001 – 300
75/128
To Next Page
Loading...
