Instruction Manual ITEM TE700 TECNA S.p.A.
40/128
It is advisable to activate the CONTROL UNIT in RO MODE and to check the limit use
conditions before proceeding with production. For instance, if use is meant to be with 2
sheets, the limit conditions are either with 1 or 3 sheets. The constant energy is adjusted by
the TE700 control unit. The operator must then check the current slicing percentage of the
inverter with 1 sheet and set this value as minimum limit. The value with 3 sheets should be
set as maximum limit.
However, it is not possible to undoubtedly assure that the piece has been effectively
welded, as all the conditions and parameters involved in the welding process
execution should be checked.
To Next Page
Loading...
