TECNA TE700 - Page 96

Instruction Manual ITEM TE700 TECNA S.p.A.
96/128
TABLE WITH SEAM WELD OPERATING MODE PARAMETERS – PRIMARY ADJUSTMENT
PROGRAM DATA T1
>TOOLS N° 1
WORKING MODE IK
CONTROL MODE NO
PARAMETER RANGE VALUE
PROGRAM N. 001 – 300
WORKING MODE IK
CONTROL MODE * NO
SQUEEZE 1 0.5 – 99.0 cycles
SQUEEZE 00.0 – 99.0 cycles
PRESSURE 00.5 – 10.0 bar
MOTOR DELAY 05 - 99 cycles
PRE-WELD 0000 – 1000 mS
PRE-CURR. 000.30 – 200.00 KA
COLD 1 0000 – 1000 mS
SLOPE UP 0000 – 1000 mS
WELD 0001 – 2000 mS
CURRENT 000.30 – 200.00 KA
COLD 2 0000 – 1000 mS
CURRENT 2 000.30 – 200.00 KA
HOLD TIME 00.5 – 99.0 cycles