P2002 Sierra
SECTION B
MAINTEN ANC E MAN UAL
pag.
B-20
2
st
Edition, April 22
th
, 2008
INSPECTION & SERVICING
N
ATURE OF INSPECTIONS
INSPECTION
I
NTERVALS
(
HRS
)
100
Special
FUEL SYSTEM
1
Check circuit lines for integrity and wetness
2
Check shutoff valves
3
Rinse tanks and clean exit filters 1200
FLIGHT CONTROLS
1
Check cables, terminals, pulleys and turnbuckles for integrity and
proper condition of aileron and rudder control
2
Check pushrod terminals, lever hinge bushings, stabilator control
pass-through
3
Check pushrod terminals and aileron control pass-through
4
Check flaps pushrod terminals
5
Check flaps actuator for integrity and play, attachment of termin-
als and electrical connections
600
6
Check torque tube, levers and attachments for flaps control
7
Check resin control lever for trim actuator 600
8
Check trim control levers and pushrods for integrity and play
9
Check rudder pedals for integrity and play
10
General check for proper tension level for control cables 600
MOVING SURFACES
1
Visually inspect integrity of the stabilator’s dacron wrap-around
(if installed) for cracks, chinks, etc.
2
Visually inspect and check integrity of wrap-around paneling for
rudder and flaps.
3
Check integrity and play of flaps and aileron hinges
4
Check integrity and play of stabilator attachments
5
Check integrity and play of trim-tab hinges
6
Check play and proper fastening of stabilator tubular spar
7
Check integrity of balance weight support
8
Check integrity and play of rudder lever and hinges