8.1.17 Cooling system overflow tank
Located on the overflow tank cap is the placard indicating the solution proportion between the antifreeze additive and the
water
8.1.18 Brake oil reservoir
On the cap of the brake’s oil tank, is a placard indicating the type of oil that must be used.
8.1.19 Tire pressures
On each steel spring leaf is a placard indicating the main tires inflating pressure (18x6mm):
On the nose gear is located the following placard indicating the nose tire inflating pressure (18x6mm):
8.1.20 Identification plate
The following placard is located on the pilot side of the empennage forward of the stabilator and made of stainless steel.
To Next Page
Loading...
