Two throttle control knobs are located on instrument panel.
One is positioned centrally while the other is on the upper
left-hand side. The following placard is near each one:
A throttle friction lock is located on the instrument panel to
maintain desired setting. The following placard is
positioned near friction lock:
Refer to section 9 for possible variations.
Fuel shutoff valves are located on cabin truss forward members. RH valve shuts
off fuel flow from RH fuel tank; LH valve shuts off fuel flow from LH fuel tank.
When valve lever is aligned with truss member, the valve is open; if lever is
rotated 90° wrt truss member, the valve is closed. A 20x8mm OPEN - CLOSED
placard is placed near each shutoff valve. The following placard is placed near the
RH forward truss member shutoff valve:
The cabin heat control knob is located on the instrument
panel central area just to the right of the throttle control;
the following placard is next to it:
The carburetor heat control knob is located on the
instrument panel central area just to the left of the throttle
control; the following placard is next to it:
The trim switch control is located on the upper central
area of the instrument panel alternatively allocating trim
To Next Page
Loading...
